![]() ![]() With the tent properly staked, drape the fly over the frame, attach its tent connection points and stake down any pull outs.Tie a piece of cord or web into a loop through the ring to be used as a large stake loop if needed. Drive stakes through the web loops, or with ring & pin, drive the stake just outside the ring so that the "J" hook catches it. You will know it's too tight, if the door zippers can not be easily operated. It is important that you don't stake the tent out too tightly. Pull the base of the tent taut between each web stake out loop or ring & pin. This enables you to square the tent up to ensure that the fly goes on properly and that the seams align with the frame. Once the tent body is erected, stake it out before the fly is put on.Securing the tent by placing heavy objects inside is just not adequate. Read and follow manufacture's instructions.Īll tents need to be staked down to keep them from blowing away. Several thin layers will work better than one thick layer. Apply sealant to the inside and outside of all exposed seams.We recommend sealing both floor and fly seams and reinforcements. There is no need to seal the seams in the roof or the factory taped seams. For example, seams that will be exposed to rain, runoff, or ground level water are a must for sealing, while seams on uncoated nylon or mesh panels don't need treatment. Taut seams allow for even application and penetration of the sealer. Set the tent up or lay the tent out flat.We recommend use of a sealer such as Kenyon Seam Sealer 3 or McNett Outdoor SeamGrip®. Combustion consumes oxygen and can produce dangerous levels of carbon monoxide, which could lead to serious injury or death. Do NOT operate any device which burns fuel inside your tent.The application of any foreign substance to the tent fabric may render the flame-resistant properties ineffective. The fabric may burn if left in continuous contact with any flame source. This tent meets the flammability requirements of CPAI-84.KEEP ALL FLAME AND HEAT SOURCES AWAY FROM THIS TENT FABRIC. Optional equipment: Floor Saver, placed under the tent, protects floor and keeps it clean. A hungry animal that smells food will chew or claw through fabric. This tent is equipped with hanging mesh pockets for small accessories and water bottles. Roll up both along with the pole bag towards the door and stow all in the main bag. Unclip, collapse the tent poles and stow in the pole bag.įold the tent/fly. Take down: Pull up stakes and open doors. NOTE: In strong winds, tie extra cords to the storm loops on the fly and stake down so that the cords are tight. 11.įasten the shock corded J-hook at each of the corners of the fly, to the rings on corners of the tent. Reach under the fly and wrap the hook and loop straps around the poles to secure the fly to the tent frame. The Eureka! logo should be over the front door. Turn the fly right side up and drape it over the top of the tent. Wrap the hook and loop fasteners around the rods to hold it in place. Place the ends of the fly rods into the pockets. ![]() Once the tent is securely staked down, spread the rain fly out upside down. NOTE: General purpose stakes are included but snow or sand stakes can be purchased at a Eureka! dealer. It works best to do this before you add the fly. Stake the opposite corners while applying tension to smooth the floor wrinkles. Stake the tent down through the corner web loops. Start at the bottom and attach all the clips to the poles to create a freestanding tent. Place the pin into the end of the pole to maintain tension. Make sure the ferrules do not get caught on the sleeves. 3.Īt the opposite end, with the pole in one hand and a pin & ring in the other, feed the pole up, bending it evenly along its length to create an arc. Place a corner pin into the end of one of the poles. The two long poles cross at the center through the sleeves and run corner to corner. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |